Tokyo Marui USP Compact Gas Blowback

Thank you for viewing.

This is a set including the Tokyo Marui USP Compact (gas blowback), 4 magazines, and other accessories.

★ Included Accessories
PDI Inner Barrel (original also included)
LayLax Hammer Spring (original also included)
Tokyo Marui Micro Pro Sight
DCI Guns Dot Sight Mount
TrustFire Weapon Light (GM23-2022)
Flat Magazine Bumpers (4 pieces)
(2 batteries for the Micro Pro Sight are included as a bonus.)

⚫︎ The slide of the gun body was replaced with a new one a few months ago.

⚫︎ The outer box is included. Please check the photos for accessories. The styrofoam inside the lid is cracked.

⚫︎ The Micro Pro Sight comes with a wrench, a small screwdriver, and a cleaning cloth, but no outer box.
It will be shipped mounted on the gun body.

⚫︎ The dot sight mount is of the type that is attached by removing the rear sight. The removed rear sight will be placed in the bag for the DCI Guns mount.

⚫︎ The under rail of the gun body has been slightly shrunk with heat to directly attach the light.
This position makes it easier to operate the light.
The included under-mount rail can still be attached, so there should be no issues with use. Please check the photos.

⚫︎ The lens of the light has melted.
The 800-lumen light is very strong, and when I applied tape to try to slightly reduce the brightness, it melted.
It still functions as a light.
It is so bright that you cannot look directly at it.
The light will be removed from the gun body and shipped in a box. This is to prevent it from accidentally turning on during transport.

⚫︎ A small piece is chipped off the part behind the hammer.
It does not seem to cause any problems when shooting.

⚫︎ Two of the four magazines had gas leaks, so the gaskets were replaced. They were kept in a ziplock bag for about 3 weeks, and the bag did not inflate, so I believe the leaks have been fixed. (This is a DIY job, not professional quality.)
The magazines will be shipped with masking tape labels.

⚫︎ The PDI inner barrel may be slightly thinner, causing some play, so the gap with the chamber has been filled with aluminum tape.
The hop-up pressure rubber is a cut 50° gasket.

⚫︎ The original hop-up gasket is installed.

Please consider this item as a used product.
Thank you.