Polar Bear ? Hot Stone Warmer

This is a hot stone warmer.
Used about 2-3 times.

There is a scratch as shown in the 4th photo, but otherwise it is in beautiful condition.

1. Place the dedicated pot into the main unit.
2. Add stones and water to the dedicated pot until the stones are covered, then close the lid.
3. Plug the power cord into an outlet and press the power button.
4. The set temperature will be displayed on the digital display. Use the + and - buttons to set the water temperature (※ The initial setting is 60℃, and it can be set between 45℃ and 99℃. If set above 90℃, errors are more likely to occur, so please use it up to 90℃).
5. When heating begins, the current water temperature will be displayed on the digital display (※ Due to the sensor mechanism, a temperature higher than the actual water temperature may be displayed at the beginning of heating).
6. Wait about 15-30 minutes for the stones to reach the appropriate temperature.
7. Once the stones are warm, remove them with the included ladle. Always check the stone temperature before use.

Only the main unit and ladle are included.
Operation has been confirmed.

Please understand that this is a used item before purchasing.