Bathtub cleaner "Botanican All-in-One Bath Wash Max 200g x 2 packets x 2 pieces

Easily clean your bathtub with enzymes and plant-derived ingredients.

- Use: Bathtub cleaning
- Ingredients: Enzymes, plant-derived
- How to use: Leave overnight for cleaning
- Capacity: 200g
- Water volume: Approx. 150L

＼100% Naturally Derived Ingredients／

Introducing a new, carefully crafted bathtub cleaner from the Botanican series, designed with people and the environment in mind!

No synthetic fragrances are used, so you don't have to worry about harsh odors.
This eco-friendly bathtub cleaner can be safely used by babies and those with sensitive skin.

Simply dissolve in leftover bathwater, run the heater for 5 minutes, and then soak the bathtub, tub, bath chairs, lids, and other bath accessories overnight for an easy bath cleaning.

Triple power of oxygen, enzymes, and plants cleans thoroughly.
Simultaneously removes scale, slime, and soap scum.

[How to Use: For Bathtub Cleaning]
1. Adjust the water level in the bathtub so it is about 5cm above the hole (or the upper hole for two-hole systems) using approximately 150L of leftover bathwater or fresh water.
* One bag is for approximately 150L. Adjust the amount of product according to your bathtub size.
* If the cover for the two-hole system can be removed, remove it at this time.

2. Add the entire contents of one bag to the bathtub and stir well to dissolve.
* Be sure to wear rubber gloves.

3. Run the heater for approximately 5 minutes.
* Approximately 40°C is the optimal temperature. Insufficient cleaning effect may occur if the water temperature is too low.

4. After running the heater, let it sit for about 8 hours.
During this time, you can also soak washbasins, bath chairs, etc., to remove dirt.

5. Before draining, run the heater again for approximately 5 minutes.

6. For one-hole systems: Drain the water from the bathtub. After draining, refill with water up to 5cm above the hole for rinsing.
Run the heater for approximately 5 minutes, then drain completely.
Remove any remaining dirt in the bathtub with a sponge, etc., and rinse thoroughly with a shower.

For two-hole systems: Use a hose to forcefully pour water into the lower hole to expel internal dirt, then drain.
If you do not completely remove the sludge, dirt may come out during bathing.

* If left for a long time, the cleaner may rarely penetrate the resin of older bathtubs and cause white discoloration.
However, this can be restored by scrubbing with a cleanser and sponge.

Although unopened, it is listed as near unused due to home storage.

Thank you for looking.