Neo Ink Line One-Push SBGCF BUT-SP Mirai Kogyo Board Opening SB Holster

Sold individually.
This is a marking adapter for single-gang boxes with a center magnet, compatible with products like Mirai Industry's SBG, Nichido Electric's SM36BG, and Point Attar NBS-3B.
Unlike previous marking one-push tools, this adapter features a retaining lip that holds it securely regardless of the spring condition of the stamp holder. The marking plate's reduced thickness (from 5mm to 3mm), made possible by carbon fiber, slightly increases the detection depth.
Due to stock depletion, the previous carbon-infused model has been discontinued and replaced by the standard Neo model.
This tool assists in marking board openings when used in conjunction with Mirai Industry's Magnet Attar BUT-SP, utilizing either the SB Hol-saw or SB Hol-saw EG.
As this product is manufactured using a 3D printer, it may exhibit characteristic product variations such as layer lines, support material marks, small voids (s), and minor burrs. However, these do not affect its functionality for marking purposes. Please understand this before purchasing.

How to use:

1. Remove the marking stamp or marking pointer (protrusion) from the BUT-SP.
2. Insert the cylindrical part of the marking one-push tool into the hole where the stamp was removed. (Ensure the orientation of the BUT-SP aligns with the cushion placement. If not aligned, a gap will form, preventing accurate marking.)
3. Turn on the power and detect the box's magnet.
4. Once the magnetic center is detected, lightly press the attar against the board.
5. The long center protrusion will pierce the board, allowing you to rotate the tool around it. Adjust the attar to be level using the built-in spirit level.
6. While maintaining the level, press the entire marking one-push tool further against the board.
7. After confirming that the remaining two marking protrusions have made marks on the board, use the SB Hol-saw or SB Hol-saw EG to cut the board opening.

The material is reinforced PETG with carbon fiber, an infill rate of 15%. Due to its thin construction, it is mostly a wall structure with no partial reinforcement.

The protrusions are consumables, similar to Mirai Industry's Mag-Kingyo. Replace them with new ones when the marking traces become difficult to see.

This tool is designed for standard boards. Using it on water-resistant boards or similar materials may shorten its lifespan.

The Magnet Attar main unit is not included.