Overflow Parts x2 Set Medaka Breeding Case Goldfish Breeding Container For Tubs and Tro-bune

↓↓ Products from Goshiki Aqua
#GoshikiAquaListings
#OtherQuantitiesAndSetsWithHoleSaws

A set of parts for overflow processing to maintain a constant water level in breeding tanks for medaka and goldfish during heavy rain or water top-offs.

Includes a flow prevention cap to prevent the escape of aquatic life (mesh hole diameter is approximately 2.5mm, so it is not suitable for newly hatched fry).

Comes with an easy-to-understand instruction manual with many illustrations, making it safe for beginners.
★A hole approximately the size of a 5-yen coin needs to be made in the breeding container (please prepare drilling tools separately).★

[Set Contents]
* L-shaped pipe, straight pipe, 2 rubber gaskets, resin plated cap x quantity listed in product name (16A, inner diameter approx. 22mm), installation manual

★The standard color is deep indigo, but gray is also available. If you wish to have gray, please contact us after purchase and state Gray Request (combinations of deep indigo and gray are also acceptable).
If no specific color is requested, deep indigo will be shipped.★

Ideal for preventing overflow in synthetic resin medaka breeding containers such as NV boxes, jumbo tarps, torofune, and purafune.

The cap can be easily attached and detached by hand for easy maintenance of dirt and clogging (mesh hole diameter is approximately 2.5mm).

With gaskets, waterproofing is not required, and the parts can be easily disassembled after installation, making storage convenient.

[Installation Procedure]
1. Determine the drilling position and, if possible, make a pilot hole with an awl or similar tool.
2. Drill a hole with a hole saw or similar tool, and smooth out any burrs or rough edges to some extent with a file, cutter, or similar tool.
3. Sandwich the gasket between the inside (or both inside and outside) of the container and pass the L-shaped and straight pipes through, then tighten by hand (light tightening by hand is sufficient).

*If the drilling position is set too high, the water level can be lowered by angling the pipe, but it cannot be raised. Therefore, setting it higher is recommended.

[Notes]
* The containers shown in the photos are not included in the product.
* Color and texture may vary slightly depending on the lot. In particular, the gray type may have a significant difference in color between the inner and outer parts.
* There are no barcode stickers that are troublesome to peel off.