Overflow Prevention Parts x5 Set Medaka Breeding Case Goldfish Breeding Container Tub Tro-bune

↓↓ Products from Goshiki Aqua
#Goshiki Aqua Listings
#Sets with different quantities or with/without hole saw

This is a set of parts for overflow modification, unused and new, designed to maintain a constant water level in breeding tanks for medaka and goldfish during heavy rain or when adding water.

Ideal for preventing overflow in synthetic resin medaka breeding containers such as NV boxes, jumbo tarps, and plastic tubs.
Comes with an easy-to-understand instruction manual with many illustrations, so even beginners can use it with confidence.

Includes an outflow prevention cap to prevent the escape of fish (mesh hole diameter is approximately 2.5mm, so it is not suitable for newly hatched fry).
★A hole the size of a 5-yen coin needs to be drilled in the breeding container★

[Set Contents]
* L-shaped pipe, straight pipe, 2 rubber gaskets, resin plated cap x quantity indicated in product name (16A, inner diameter approx. 22mm), installation manual

★Standard color is deep indigo, but gray is also available. If you wish to have gray, please contact us after purchase stating Gray preferred (combinations of deep indigo and gray are also acceptable).
If no preference is specified, deep indigo will be shipped.★

The cap can be easily attached and detached by hand for easy maintenance of dirt and clogs (mesh hole diameter is approximately 2.5mm).

With gaskets, no waterproofing is required, and it can be easily disassembled after installation, making it convenient for storage of the container.

[Installation Procedure]
1. Determine the hole drilling position and, if possible, make a pilot hole with an awl or similar tool.
2. Drill the hole with a hole saw or similar tool, and smooth out any burrs or rough edges with a file, cutter, or similar tool.
3. Sandwich the gasket on the inside (or both inside and outside) of the container, insert the L-shaped and straight pipes, and tighten by hand (light tightening by hand is sufficient).

※If the hole drilling position is set too high, you can adjust the water level by angling the pipe, but you cannot raise the water level, so a slightly higher position is recommended.

[Notes]
?The containers shown in the photos are not included in the product.
?Color and texture may vary slightly depending on the lot. In particular, the gray type may have a significant difference in color between the inner and outer parts.
?There are no barcode stickers to peel off, which can be troublesome.