eGPU NFHK N-8611Y-D OCuLink 0.5m External Graphics Card

This is a kit for externalizing a graphics card.
It connects to your PC using an OCuLink cable.
The cable is approximately 50cm long.
This is a new, unopened item.

To operate, you will need a separate power supply unit and graphics card.
I am currently using one unit with a GMKtec K12 and a Radeon RX 9060 XT, and it is working correctly with Gen4 x4.
Based on benchmark results, there appears to be almost no performance degradation from the Gen4 x4 connection.
I also did not experience any WHEA errors, which can occur with poor quality cables.
The unit has a power switch, but it remains in the OFF position and automatically turns on/off in sync with the PC's power.

If your PC does not have an OCuLink port, I can include an M.2 conversion card (see photos 4-5).
The M.2 conversion card is an additional ¥1,000, and the extended long type is an additional ¥1,800.

You can use it by connecting the OCuLink cable to the M.2 conversion card and inserting it into an M.2 NVMe slot inside your PC.
*Note: The power synchronization function did not work with the M.2 connection.
Please let me know via the question section if you would like this option.

As it is new, I don't expect any issues, but due to the niche nature of this product, I cannot guarantee its operation.
Compatibility issues or unexpected problems may occur.
Also, Oculink does not support hot-swapping, so please ensure the power is completely turned off before installing or removing it.
Recommended for advanced DIY PC builders with sufficient knowledge.

It will be safely packed with bubble wrap and shipped immediately (within 24 hours) via Yu-Packet Post.
I will respond promptly and courteously.
Thank you.