Tonearm Lifter Filling Silicone Oil (Grease) 3 Viscosity Types Set

This is a high-purity industrial silicone oil ideal for refilling (applying) tonearm lifters over time.

We offer a set of three different viscosities: 1,000,000 cSt / 500,000 cSt / 200,000 cSt.

Each bottle contains approximately 2cc, which is more than enough even for tonearms that use a generous amount of oil, like SME models.

The ideal viscosity mixture varies depending on the manufacturer and model.

Based on my experience, a mixture in the range of 400,000 cSt to 600,000 cSt is often suitable.

First, please note that mixing the oils takes time (to remove air bubbles).

Basically, work without rushing and slowly, perhaps on a relaxed weekend.

A good tip is to first fill with 500,000 cSt as the first take, then loosely assemble and check the descent speed with a stylus pressure of 2.0g as a reference.

If you want to speed up the descent slightly, add a small amount of 200,000 cSt to create a mixture around 400,000 cSt.

Conversely, if you want to slow down the descent, add a small amount of 1,000,000 cSt to create a mixture around 600,000 cSt.

In most cases, the tonearm lifter will work well with the second mixture.

For even finer adjustments, mix in very small amounts following the above process.

Please note that silicone oil is extremely viscous.

When you mix and thoroughly stir the oil, air bubbles will be incorporated.

For ultra-high viscosities close to 1,000,000 cSt, it may take over an hour for the air bubbles to dissipate.

Finally, ensure that all air bubbles have completely escaped and the oil is clear before filling (applying).

Please ensure you have adequate workspace, as your hands may become sticky with oil during the process.

[Work Example Image]
YAMAHA GT-2000 (Image courtesy of Knack Audio's blog)