sE Electronics DM1 DYNAMITE Mic Preamp

I was using this as a preamp for my dynamic microphone until recently.

I've also used the CLASSIC PRO CSB1 and Triton Audio FetHead, but this sE Electronics DM1 DYNAMITE provides the highest signal level amplification.

■ Features
Clean and stable +28dB gain, independent of load
・Neutral and balanced sound quality
・The best tool for boosting passive microphone signals
・Consistent gain maintained regardless of connection load
・Provides significantly improved levels to the microphone preamp for proper gain staging

Sophisticated Class A electronics
・Class A electronics and high-grade FETs achieve ultra-low noise
・Transformerless design faithful to the source's original sound quality
・Lowest noise in its class

Dedicated output buffer amplifier
・Provides +28dB output regardless of load impedance or cable length
・Extremely low output impedance
・Reduces the effects of RF interference, buzz, and hum even with long cable runs

Slim, robust metal housing and premium finish
・Efficiently eliminates all electrical interference and noise
・High-quality finish and gold-plated XLR connectors ensure reliable signal connections
・Slim design allows for easy setup in studios and on stage

■ Specifications
Frequency Range: 10 Hz - 120,000 Hz (-0.3 dB)
Gain: 28 dB (1kΩ load)
Maximum Output Level (0.5% THD): 8.3 dBV (2.6 V)
Output Noise Level: 9 μV (JIS-A)
Operating Power: 48V Phantom Power (Compliant with IEC 61938)
Impedance: 135Ω
Recommended Load Impedance: 1kΩ or higher
Current Consumption: 3.0 mA
Connector: XLR 3-pin
Dimensions: 19 mm (Diameter) x 95.5 mm (Length)
Weight: 80 g

■ Please Note
The DM1 is designed for passive microphones (dynamic and ribbon microphones). It cannot be used with microphones that require phantom power (condenser microphones or active ribbon microphones).



Streaming, Live Streaming, Gaming, VTuber, Singing, Utattemita (I tried singing)