[Wi-Fi 6 Compatible] BUFFALO WEX-1800AX4 Repeater 2-Pack

【Product】
BUFFALO
Set of 2 Wi-Fi 6 Compatible WEX-1800 AX4 Repeaters
Wi-Fi Repeater
11ax 1201Mbps (5GHz) / 573Mbps (2.4GHz)

[Usage Status]
Acquired from a certain website around January 2026! This product was used as a mesh Wi-Fi device along with a WSR6000ax8 unit that had been used for about half a year.
The manufacturing date is unknown, but I saw online comments suggesting that the management logs of Buffalo Station could be used to determine it. Upon checking, it indicates January 2024, so it's likely manufactured in 2024. However, this is not confirmed information, so please consider it as a reference.

One unit has a black stain-like mark.
Both units were used in a mesh Wi-Fi setup with the WSR 6000ax8, and as of April 29, 2026, there are no operational issues!
It can also output received Wi-Fi signals via a wired LAN connection, allowing for various uses!
Original packaging is not included.
The product shown in the photos will be wrapped in bubble wrap and shipped in a recycled cardboard box!

Please ask any questions before purchasing.

【Features】
Expand your Wi-Fi area with Wi-Fi 6 (11ax)
Both 5GHz and 2.4GHz support Wi-Fi 6

This product supports Wi-Fi 6 (11ax), which is strong for high-capacity and multi-device communication. It can extend your Wi-Fi area by high-speed relaying the signals from your Wi-Fi router (wireless LAN access point). It is also compatible with Wi-Fi 5 (11ac) and earlier wireless standards, ensuring comfortable connectivity for non-Wi-Fi 6 devices as well.

[How to set up Mesh Wi-Fi]
If the distance is about 7m, connection should be possible according to the manual at the installation location, but it may vary depending on the environment. Therefore, it is recommended to set it up near the access point according to the manual and then move it to the installation location.

After connecting this unit (Agent), wait for about 1 minute for stability, then press and hold the WPS button on this unit for more than 2 seconds! When the WPS button on the far right blinks twice, press and hold the WPS button on the access point (Controller) for more than 2 seconds. Wait for the wireless lamp to blink twice, and then wait for the connection.
Perform the same procedure for the second unit.
For details, please refer to the manufacturer's website or the attached manual, which can be screenshotted from the HP!

#WEX-1800 AX4