Canon Mobile Power Cable for Tube Printer

This is a cable for using Canon tube printers with a QC3.0 mobile battery.

The length is approximately 90cm.

This is a USB cable with a built-in trigger device that outputs 12V from a QC3.0 mobile battery.

It can only be used with a QC3.0 mobile battery.

Please read the mobile battery's instruction manual carefully before purchasing.

The image shows an example of use with an MK2100.
It can also be used with MK2000, MK2500, and MK2600.

For the mobile battery, we recommend a QC3.0 or higher model with a 12V output from the USB-A port and a capacity of 10,000mAh or more.
Recently, prices for 20,000mAh batteries have been decreasing, so we recommend a 20,000mAh model.

When using the heater, it consumes 0 to approximately 450mA for the heater alone.
During printing, it consumes approximately 500-600mA, for a total of up to approximately 1100mA.
It consumed 130mA during data input.
Please use this as a reference.

Regarding usage time:
With the heater set to Hi, printing 9 digits of 3mm full-width characters on 800 tubes of 32mm length, a 20,000mAh mobile battery consumed 15% of its capacity.
This means a 20,000mAh mobile battery can be used for approximately 5,000 tubes, which should be sufficient for practical use.

Charging the battery is also easy as it can be charged via USB.
I also use it on new construction sites, and I recommend it for its compactness.

We tested it with four different mobile batteries.
We have included images of the four mobile batteries for your reference.

Please note that only the cable shown in the first image will be provided. Do not make any mistakes.