FMW Rear Receiver & Base for Horizontal Pins

This is a rod holder that can secure your rod with a horizontal pin specification.
The diameter of the 12mm thick horizontal hole is 10mm. (Perfect size for Daiwa Genpao Kue)
Basically, it can be used with a single anchor, but if the installation location is a weak rock like sandstone, you can achieve a stronger fixation by using a double anchor. (When installing with a single hole, please use the smaller hole.)
The base is threaded, allowing for slight height adjustment. While the adjustment range is not large, you can raise or lower the rod tip to some extent by slightly moving the butt end up or down.
*Caution: Even when raising the rod, always ensure it is screwed in at least 8 turns. Insufficient screwing may cause it to detach.

Manufacturer: FMW
Material: Super Duralumin
Bolt holes accommodate M10, 3/8 to M12.

■About the Material
Made from super duralumin, a lightweight and high-strength material also used in aircraft.
Its specific gravity is 2.8g/cm3, less than half that of stainless steel (7.93g/cm3), making it lightweight. Furthermore, its tensile strength is approximately 570N/mm2, higher than stainless steel's approximately 520N/mm2.
Each piece is machined from raw material, which inevitably increases the cost, but the absence of welding points reduces the risk of breakage.

[Stone鯛,アラ, Kue fishing, Bukkomi fishing, Bottom fishing, Piton, Ishizuki BOX, Rod holder]