Marui USP Gas Blowback Compensator

This is a compensator compatible with the Marui USP gas blowback.
(We also handle electric gun versions for the same price.
Please comment if you are interested.)

I believe it has a design that strongly evokes a tactical image.
A rail is attached to the bottom, allowing for the installation of optical attachments.
Since the slide will not drop even when pressed, firing is possible,
so it can also be considered as a strike face for close-quarters combat.

Insert one of the included protective plates into the groove on the right side of the frame,
aligning the groove with the screw, and then fit the compensator.
Once you confirm the plate is fully inserted, tighten the set screw to complete the installation.
Be careful not to overtighten.
An extra plate is also included.

■Important Notes
The compensator, set screw, and two protective plates (one is a spare)
are included in this listing.
Use a 1.5mm hex wrench and tighten lightly.
The gun is not included.
Due to the structure, it may come off if struck forcefully.
Please handle with care.

The design is subject to change for improvement.
As this is a custom product made with a 3D printer,
there may be some roughness or minor scratches as shown in the photos.
Please refrain from purchasing if you are sensitive to such details or concerned about the condition.

The material is carbon fiber PLA.
While it has a certain degree of strength,
it differs from commercially produced products and
is weak to heat above 60℃.
Please be especially careful in hot environments such as inside a car under the summer sun.
We offer a 2-week warranty against breakage.

Reselling at high prices and unauthorized use of images are prohibited.
Please be aware of high-priced resellers on platforms like Amazon.