Crown Air Cocking (18+): Colt Python 20mm Rib Mount Rail, Recessed Type

Crown Air Cocking Gun (18+): 20mm Rib Mount Rail for Colt Python 357 Magnum.
*This is the type with a dent on the upper surface. A dent-free type is also listed separately.

It is attached by inserting it into the rib holes and tightening with M1.2-2.5mm screws (a Phillips head precision screwdriver is required). The dimensions are a snug, tight fit. If a scope mount is always attached and tightened to this mount rail, the M1.2 screws may not be necessary. (The M1.2 screws will be shipped detached and secured with tape; please be careful not to lose them upon opening.)

It cannot be attached to the foremost rib hole near the muzzle.

Attachment to the rib holes allows for placement shifted approximately 1cm to either the front or back width of the rib hole.

The image shows an example of attachment to a Colt Python .357 Magnum. The listing is for the mount rail (front and rear, 2 pieces as a set) only. The gun itself is not included in the listing.

In addition to the Crown (Air Cocking Gun, 18+) model, it has been confirmed to fit the older Tanaka Colt Python gas gun (not the Pegasus system, photo included), which is likely owned by few people due to its age.
It cannot be attached to products from other manufacturers.

This product is made with a 3D printer using PLA material.
Please only bid if you understand that this is a 3D printed item. It may have 3D printer artifacts such as layer lines, extrusion marks, burrs, stringing, fuzziness, printing irregularities, etc., as well as scuff marks from filing and adjustment.
It may deform in environments above 70°C.

We are not responsible for any injuries or damages caused by this product.

Product specifications are subject to change without notice.

Please, no claims, no returns.