Folding Rod Stand, Heavy Duty, DOKAT, 1 Set, Rod Holder

Folding Rod Holder (Heavy Duty) - 1 set.
For DUCAT 4700, ring diameter 36mm, offset 47mm.
The size can be adjusted, so it can also be used as a landing net holder.

Only the top part can be folded.
The bottom part can be detached, and a magnet is embedded on the contact surface.
Easy to install and store, it folds and detaches to fit inside the DUCAT handle.
Personally, I feel it has plenty of capacity even with a 4kg load applied with a spring scale.
When storing, lifting the ring automatically raises the bar for storage fixation, so with practice, you can install and store it with one hand.
It is made to match the taper of the DUCAT side. Please install it by aligning the surfaces with the arrows. Align so that the arrows on each part meet.

If you purchase only the upper folding part and the lower base part, you can also reuse the detachable lower ring. Please comment if you would like us to list it for 2100 yen.

The fully folding type (both top and bottom) is listed separately, so please check it out.

You can add a pilot hole adapter for easy attachment to DUCAT and a socket for thinner rods (under 12mm) for the following additional fees.
After drilling a 2mm hole, please expand it to 5mm.
Pilot hole adapter: 100 yen
Socket: 150 yen

This is made for DUCAT 4700, but if you are looking for an offset for the 5000 model or a change in ring diameter, please comment and we will create it for you.

Please understand that this is 3D printed and handmade.
There may be layer lines or irregularities in the printing.