Telecaster Control Panel Plate, Wood, 33mm Width

This was included when I was building a custom guitar, but I used different parts, so this is extra. It can be used to replace the control panel section.
I applied a small amount of genuine lacquer, which was leftover from the build, to slightly reinforce the strength.
If you have a kit with pre-installed parts, replacement is easy: remove the control knob nuts, turn the screw next to the selector, and pull off the cover above the switch.
However, this is the 33mm width type, so please check if it can be installed before purchasing. Also, I believe this is intended for those experienced with modifications. Installation is at your own risk. Therefore, I would appreciate it if only those who understand these points would purchase.

Added 4/21
This is for those who plan to modify, but if you replace the control plate from metal to this wooden one, the ground for the volume knobs etc. may not escape. Therefore, you may need to process it by wiring a ground wire again to escape. Please be aware of this.
Also, I had planned to ship via Nekoposu, but since the nearby convenience store has closed, it will be via Yu-Packet. I apologize for this.