O-ring for WA gas blowback valve, 2 sets. Compatible with overseas brands like Tanaka and WE.

WA Western Arms Fill Valve O-Ring Set of 2 for Tanaka, WE, and other foreign brands
*Valve and magazine not included.

For WA, Tanaka, WE, and other foreign brands with a fill valve head diameter of 7mm.

Set includes:
2 O-rings for the exterior (M5) and 2 O-rings for the interior (needle).
The exterior O-ring has a 1.5mm cross-section, and the interior O-ring has a 1mm cross-section.

*If you refer to Image 2 and find that the 1mm cross-section is more suitable, please contact us via comment or transaction message, and we can make the change.

Please note that this may not be suitable for fill valves that seal gas by tightening a resin washer instead of an O-ring (structures where the valve mounting part is simply threaded and the O-ring or valve head is not recessed).
It will be fine if tightened lightly, but
if overtightened, the O-ring may be crushed, escape outwards, or tear.

■Other
WA 1911 magazines have rough finishes, leaving large burrs on the inside of the base pin hole.
This can cause the base gasket to be shaved off when attaching or detaching the base. If there are burrs, please remove them before reattaching.
It would be a shame to fix gas leaks from the fill valve only to have leaks from the base...

#WAMagazineRepair
#MagazineRepair

------
Airsoft Custom Gas Blowback Gas Gun Gasket
Maintenance Gas Leak Repair
WE WE-tech