New power switch for FERNANDES ZO-3

Thank you for looking.

This is a new red power switch, commonly used for Fernandes ZO-3 and DIGI-ZO models.

◆ The diameter of the threaded part is approximately 5.8 mm.
This is a standard 2-contact ON/OFF (ON-ON) toggle switch, SPDT type.

Please be sure to read the following precautions before considering your purchase.

[Precautions 1]
This switch may not fit all ZO-3 models.
Please note that we cannot provide support if it does not fit after purchase.

[Precautions 2]
The red body is sensitive to heat, so please solder quickly.
If you are not experienced with soldering, be careful not to melt the switch with heat.

[Precautions 3]
One of the hex nuts must be screwed onto the base of the switch.
If you tighten the nut from the front without attaching this nut, the threaded part may come off. Please be sure to attach it.

[Precautions 4]
If the exposed threaded part from the front is insufficient to attach the front fixing nut, please recess the body where the internal nut makes contact.

Some technical skill is required for installation, so if you are not experienced, please ask someone who is.

Thank you for your understanding and purchase.

This item will be shipped via standard mail (registered or unregistered).
Please understand that we cannot be held responsible for delivery status or insurance.

*Standard mail does not deliver on weekends or holidays, so it may occasionally take up to a week for delivery.

*Please refrain from negotiating the price of this item.